Operations below 60°F (15.6°C) will require the heater option for the cutting oil reservoir. Proper circulation of the cutting oil throughout the machine is critical. Depending on the ambient temperature it may be necessary to allow time for the oil to warm up enough to circulate freely.

Recommendations

1. Do not perform coning or threading operations until oil flows from the tubes.
2. Never start the heater without the proper level of oil in the tank (the heater can damage if not immersed in the oil fully).
3. Applies to Model AEGCTM-2E-CE only: AEGCTM-2E-CE Coning and Threading machines equipped with an oil heater utilize an over-current protected heating element rated for 8.9 amps. Attempts to modify, override or bypass this device will void the warranty and may result in an electrical fire or damage to the components. An optional thermostatically controlled immersion heater is available for use in cold weather. Cutting fluid should be Parker AE Part No. P-8699.
4. The oil heater is preset at the factory and should not need adjusting.
5. If for some reason, the oil heater fails to operate properly, contact us and we will try to help you.