ETH0621 - 24v Motor controller 5A - Ethernet

The ETH0621 offers 6 digital inputs (accepting 10V - 24V), 2 independently switched 24V 5A outputs  and a 24 volt, 5A motor controller that effortlessly integrates motion control over Ethernet. The ETH0621 also includes a motor surge protection circuit that shuts the motor down in the event of the current exceeding 22A.  

Operating Temperature
-40C to +85C

LED Indication

The ETH0621 provides a blue LED for indication of power to the board, this will pulse quickly in the event of the firmware being updated and for 400ms every 2 seconds in the event that the board has detected a current surge and shut the motor down. There are red LED's mounted next to the digital outputs and relays to indicate there state. Green LED's are mounted next to each of the 6 inputs to indicate active inputs. 

Relay Power Rating

If the contact load voltage and current of the relay are in the region enclosed by the solid and dotted lines in the figure below, the relay can perform stable switching operation. If the relay is used at a voltage or current exceeding this region, the life of the contacts may be significantly shortened.

Guide (PDF)